PCB cover for EMI Shielding
Shield covers are one of the most efficient and economic solution for EMI shielding on PCB.
A shielding cap creates a Faraday cage around the component that emits parasitic frequencies.
This shielding solution is very well known. However, there are some specific features to bear in mind when choosing the part and the technology.
Composition of the shielding solution :
Depending on the design constraints you have on your PCB, there are several solutions available to you:
- A single cover soldered directly to the PCB
- A belt soldered to the PCB to which the shielding cover is attached
- Clips soldered to the PCB to which the shielding cover is attached.
The single covers are soldered directly onto the PCBs or clipped onto the PCB using clips soldered to the earth connection point. The use of clips facilitates maintenance. Depending on the design of the parts, some covers can be cut to size. Most of these parts are made to measure to meet any specific requirements.
Clips for grounding the PCB have the advantage of limiting the buckling of parts and grounding specific points. However, shielding belts can be designed as multi-cavities directly.
These EMC shielding parts must have specific mechanical characteristics.
Against oxidation: The most commonly used material is stainless steel. However, tinning is often altered during shield shaping operations (cutting, stamping, bending, etc.).
The best alternative to these problems is Nickel Silver (made from Nickel, not steel). This material has intrinsic resistance to oxidation. This does not increase the risk of oxidation following shaping operations.
To ensure regular assembly and disassembly for the maintenance of the armoured components, the alloy of the armoured parts is adjusted to ensure sufficient flexibility and elasticity.
Alloys are adjusted according to the dimensions and functions of the armour.
Most of this shielding parts are custom made. Compelma realizes the tooling associated to the part and the quantities required. For prototyping or small quantities we use only soft tooling (lower cost than a standard tool but not adapted for mass production).
For automation (SMD – Surface Mounted Device) parts are designed with a tip on the top of the parts. this allows pick and place operation.
To adapt the parts to automation, Compelma proposes different packaging as trays or reels. This packaging parts are also custom designed to fit every parts.
To conclude, those shielding parts are mainly designed on demand to perfectly fit your application. For more information, give us a call, our team will be pleased to help you.